Flashing 2nd and 3rd red LED

[Les]

Hi, 

Anyone knows why my hotspot has the 2nd and 3rd red LED lights flashing consistently? The 1st green LED and the 6th red LED remain lit.

The hotspot was set up about 2 days back, and the lights were fine, with 2 witnesses and mining a little. Now, the 2 lights just keep flashing, and I cannot even do BT pairing after rebooting.

Would greatly appreciate any help or advice.

Cheers.

[Erik]

On 6/23/2022 at 4:38 AM, Les said:

Hi, 

Anyone knows why my hotspot has the 2nd and 3rd red LED lights flashing consistently? The 1st green LED and the 6th red LED remain lit.

The hotspot was set up about 2 days back, and the lights were fine, with 2 witnesses and mining a little. Now, the 2 lights just keep flashing, and I cannot even do BT pairing after rebooting.

Would greatly appreciate any help or advice.

Cheers.

Have you got a name for this hotspot?

[osyrixx]

Same problem with my hotspot. Erik, please OPEN DISCUSSION!

[rybble14]

 

Hi

I have the same problem. LEDs 2 and 3 have been flashing fastly since this morning. No more signal..., my hotspot:: Trendy Latte Pheasant.

 

I just emailed support.

https://explorer.helium.com/hotspots/11PcxfpSrQQraCzQ3b9KyXDkUbsTaBYD7d1kqN8mrXUPiyhErQE

[Casey]

On 7/5/2022 at 9:47 PM, rybble14 said:

 

Hi

I have the same problem. LEDs 2 and 3 have been flashing fastly since this morning. No more signal..., my hotspot:: Trendy Latte Pheasant.

 

I just emailed support.

https://explorer.helium.com/hotspots/11PcxfpSrQQraCzQ3b9KyXDkUbsTaBYD7d1kqN8mrXUPiyhErQE

I just had a look at your Hotspot, and I didn't find any issues with it. Are you still experiencing this problem?

[osyrixx]

On 7/5/2022 at 10:47 PM, rybble14 said:

 

Hi

I have the same problem. LEDs 2 and 3 have been flashing fastly since this morning. No more signal..., my hotspot:: Trendy Latte Pheasant.

 

I just emailed support.

https://explorer.helium.com/hotspots/11PcxfpSrQQraCzQ3b9KyXDkUbsTaBYD7d1kqN8mrXUPiyhErQE

Hi rybble14,

although your Hotspot seem to work for the moment, be prepared that you need to power cycle it after a few days or after an update. I have the same behavior.

@Les @rybble14

Could you please check which model numer you have?

Mine is LD-1001 and I think this was a bad batch and Linxdot just ignores my messages regarding a hardware issue. Maybe your model numbers are the same?